Rebooting diagram summary
1. Device connection
- Plug the junction box cable into the datalogger.
- A blue light comes on briefly, then turns solid red:
- this means that the unit is in the initialization
- phase. (1)
2. Network connection
After initialization, a flashing red light appears: the device is trying to connect to the network. (2)
Then, a flashing green light should appear: The network has been successfully found. (3)
Next, the light turns solid green: The device is connected to the network. (4)
Finally, the light goes out completely:The connection was successful, and the device is now operational. (5)
Special case - Yellow flashing light
If a flashing yellow light appears during the connection stage (between red and green), this
indicates a connection error.
--> Disconnect the datalogger cable.
--> Wait until all lights are off.
--> Reconnect the cable and start the installation from the beginning.
